Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 8)

Page 7

SAFETY INSTRUCTIONS

d) Support large panels to minimize the

risk of blade pinching and kickback.

Large panels tend to sag under their own

weight. Supports must be placed under

the panel on both sides, near the line of

cut and near the edge of the panel.

e) Do not use dull or damaged blades.

Unsharpened or improperly set blades

produce narrow kerfs causing excessive

friction, blade binding and kickback.

f) Blade depth and bevel adjusting locking

levers must be tight and secure before

making cut. If blade adjustment shifts

while cutting, it may cause binding

and kickback.

g) Use extra caution when making a

‘plunge cut’ into existing walls or other

blind areas. The protruding blade may

cut objects that can cause kickback.

4. Safety instructions for saws with inner

pendulum guard

a) Check lower guard for proper closing

before each use. Do not operate the

saw if lower guard does not move

freely and close instantly. Never clamp

or tie the lower guard into the open

position. If saw is accidentally dropped,

lower guard may be bent. Raise the

lower guard with the retracting handle

and make sure it moves freely and does

not touch the blade or any other part, in

all angles and depths of cut.

b) Check the operation of the lower guard

spring. If the guard and the spring are

not operating properly, they must be

serviced before use. Lower guard may

operate sluggishly due to damaged parts,

gummy deposits, or a build-up of debris.

c) Lower guard should be retracted

manually only for special cuts such

as’ plunge cuts’ and ‘compound

cuts’ .Raise lower guard by retracting

handle and as soon as blade enters

the material, the lower guard must be

released. For all other sawing, the lower

guard should operate automatically.

Always observe that the lower guard is

covering the blade before placing saw

down on bench or floor. An unprotected,

coasting blade will cause the saw to walk

backwards, cutting whatever is in its path.

Be ware of the time it takes for the blade to

stop after switch is released.

5. Use only with battery and charger

listed below.

Battery pack Charger

252-8024

252-8029

252-8030

252-8031

252-8032

252-8033

252-8034

252-8036

252-8037

252-8044

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare