Page 20
MAINTENANCE
oil, grease and sawdust or woodchips,
and store tool in a dry place.
5. Be certain that all moving parts are well
lubricated, particularly after lengthy
exposure to damp and/or dirty conditions.
LUBRICATION
All of the bearings in this tool are lubricated
with a sufcient amount of high-grade
lubricant for the life of the tool under normal
operating conditions. Therefore, no further
lubrication is required.
CHANGING THE BLADE (FIG. 19)
WARNING:
A 6 1/2-in. blade is the
maximum blade capacity of the saw. Use
only 6 1/2-in. blades when replacing worn
or damaged blades. Never use a blade that
is too thick to allow the outer blade washer
to engage with the ats on the spindle.
Thicker blade will prevent blade screw
from securing blade on spindle, resulting
in serious personal injury.
WARNING:
Be sure to wear protective
work gloves while handling a saw blade.
The blade can injure unprotected hands.
1. Remove battery pack from the saw.
2. Loosen the depth of cut adjustment lever.
Raise the saw to the maximum height and
tighten the depth of cut adjustment lever.
3. Locate and remove the hex key from the
storage area.
4. Depress the spindle lock button, place
hex key in the blade screw and move the
hex key back and forth until you feel the
spindle lock button depress further. This
action locks the blade in position so the
blade screw can be removed. With the
spindle lock button rmly depressed, turn
the blade screw clockwise to remove.
5. Raise the lower blade guard using the
blade guard lever and hold it in the
raised position.
6. Remove the blade screw and the outer
blade washer and the blade.
7. The remaining washer is the inner bushing
washer that ts around the spindle shaft
and does not need to be removed.
8. Put a drop of good-quality machine
oil onto the inner bushing washer and
outer blade washer where they will
contact the blade.
9. Place a new saw blade inside the lower
blade guard, onto the spindle shaft and
against the inner bushing washer.
NOTICE: The teeth of the blade should
point upward at the front of the saw.
10. Replace outer blade washer.
11. Depress and hold spindle lock button as
you replace the blade screw and hand
tighten the screw in a counterclockwise
direction. Use the hex key to tighten the
blade screw securely.
12. Return hex key into the storage area.
NOTICE: Never use a blade that is too thick
to allow the outer blade washer to engage
with the at side of the spindle.
FIG. 19
Direction of blade
rotation (teeth
point up at front
Place a
drop of
goog-quality
machine oil
Outer
blade
washer
Inner bushing washer
Blade screw
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern