Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 18)

Page 17

OPERATION

FIG. 14

TO ADJUST BEVEL SETTING (FIG. 14)

MAKING A BEVEL CUT (FIG. 15)

1. Remove the battery pack from the saw.

2. Loosen the bevel adjustment knob by

rotating the knob counterclockwise.

3. Tilt the base until the bevel indicator

reaches the desired setting on the bevel

scale (0°-50°).

4. Tighten the bevel adjustment knob by

rotating the knob clockwise.

1. Secure workpiece with clamps. When

making a bevel cut, hold the saw rmly

with both hands.

2. Rest the front edge of the base on the

workpiece. Depress the lock-off button

and squeeze the trigger switch to start

the saw. Allow the saw to reach full

speed before attempting to make a cut.

3. After completing the cut, release the

trigger switch and allow the blade to

come to a complete stop. After the blade

has stopped, remove the saw from the

workpiece.

4. When making 45° bevel cuts, there is a

notch in the saw base to help you line up

the blade with the line of cut. Align your

FIG. 15

Line of cut

45°indicator

line of cut with the right side of the notch

by the 45° indicator.

WARNING:

Attempting bevel cut

without bevel adjusting locking knob

tightened can result in serious injury.

0° BEVEL STOP

The saw has a 0° bevel stop has been adjusted

before shipment to assure that the blade is

vertical to the base at 0°bevel cutting.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare