Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 15)

Page 14

STARTING/STOPPING THE SAW

(FIG. 7)

To start the saw:

1. Depress the lock-off button.

2. Depress the trigger switch. Always let

the blade reach full speed, then guide

the saw into the workpiece.

To stop the saw:

Release the trigger switch.

After you release the trigger switch, allow

the blade to come to a complete stop. Do

not remove the saw from the workpiece

while the blade is moving.

DEPTH OF CUT ADJUSTMENTS

(FIG. 8)

Always keep the correct blade depth

setting. The correct blade depth setting for

all cuts should not exceed 1/4 inch below

the material to be cut. Excess blade depth

will increase the chance of kickback and

cause the cut to be rough. One blade tooth

below the material to be cut works best for

efcient cutting action.

TO ADJUST BLADE DEPTH

1. Remove the battery pack from the saw.

2. Loosen the depth-of-cut adjustment lever.

3. Determine the desired depth of cut.

OPERATION

4. Hold the base of the saw at against the

edge of the workpiece and then raise or

lower the saw until the indicator mark

on the bracket aligns with the desired

depth-of-cut mark.

5. Tighten depth-of-cut adjustment

lever securely.

OPERATING THE SAW

(FIG. 9- FIG. 10)

It is important to understand the correct

method for operating the saw. Refer to the

gures in this section to learn the correct

and incorrect ways for handling the saw.

FIG. 8

FIG. 9

WRONG!

FIG. 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Master-force 241-0428 Betreibershandbuch Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Master-force 241-0428