Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 19)

Page 18

TO CHECK 0° BEVEL STOP

(FIG. 16)

1. Remove battery pack from the saw.

WARNING:

Always remove the

battery pack from the tool when assembling

parts, changing blades and making

adjustments. Failure to obey this warning

could cause serious personal injury.

2. Using a carpenter’s square, check the

squareness of the saw blade to the base

of the saw.

TO ADJUST 0° BEVEL STOP

(FIG. 17)

OPERATION

Blade

Base

Carpenter’s square

FIG. 16

1. Remove the battery pack from the saw.

2. Loosen the bevel adjustment knob.

3. Place the saw in an upside-down position

on a workbench.

4. Using a Philips-screwdriver, turn the

0°bevel stop adjusting screw until the

base is square with the saw blade.

WARNING:

Attempting to make cuts

without the bevel adjustment knob securely

tightened can result in serious injury.

POCKET CUTTING (FIG. 18)

WARNING:

Always adjust the bevel

setting to zero before making a pocket cut.

Attempting a pocket cut at any other setting

can result in a loss of control of the saw,

which can result in serious injury.

1. Remove the battery pack from the saw.

2. Adjust the bevel setting to zero.

3. Set the blade to the correct blade

depth setting.

4. Place battery pack in saw.

5. Swing the lower blade guard up using

the lower blade lever.

NOTICE: Always raise the lower blade

guard with the lever to avoid serious injury.

6. Hold the lower blade guard up by the lever.

FIG. 17

0° bevel stop

adjusting screw

Lower

blade guard

Lower blade

guard lever

Guideline

FIG. 18

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare