Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 12)

Page 11

the battery pack can cause damage to

internal components.

BLADE GUARD SYSTEM (FIG. 2)

The lower blade guard attached to your

saw is there for your protection and safety.

It should never be altered for any reason.

If it becomes damaged or begins to return

slowly, do not operate the saw until the

damaged guard has been repaired or

replaced. Always leave the blade guard in

operating position when using the saw.

DANGER:

When sawing through

a workpiece, the lower blade guard does

not cover the blade on the underside of

the workpiece. Since the blade is exposed

on the underside of the workpiece, keep

hands and ngers away from the cutting

area. Any part of your body coming in

contact with the moving blade will result in

serious injury.

CAUTION:

Never use the saw when

the blade guard is not operating correctly.

Check the guard for correct operation

before each use. The guard is operating

correctly when it moves freely and readily

returns to the closed position. If you drop

the saw, check the lower blade guard and

bumper for damaged at all depth-of-cut

settings before reuse.

TO ATTACH BATTERY

PACK (FIG. 1)

NOTICE: Use with the battery pack listed

on page 8 only.

1. Make sure that the circular saw is “OFF”

2. Align the raised rib on the battery pack

with the grooves on the bottom of the

saw, and then attach the battery pack to

the saw.

NOTICE: Make sure that the latch on the

battery pack snaps into place and the

battery pack is secured to the tool before

beginning operation.

TO DETACH BATTERY

PACK (FIG. 1)

1. Lock the trigger switch on the saw by placing

the direction of rotation (forward/ reverse/

center lock) selector in center position.

2. Depress the battery release buttons

located on the front of the battery pack

to release the battery pack.

3. Pull forward on the battery pack to

remove from the tool.

CAUTION:

when placing battery

pack on the tool, be sure that the raised rib

on the battery pack aligns with the groove

on the saw and that the latches snap into

place properly. Improper assembly of

OPERATION

FIG. 1

Lower blade guard is in up

position when making a cut

Blade exposed on

underside of workpiece

FIG. 2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare