Master-force 241-0428 Betreibershandbuch PDF herunterladen (Seite 17)

Page 16

Marked along the base across the front of

the saw is a ruler for measuring repetitive

cuts. It is marked 1-1/2 inches to the left of

the 0° mark and 4-1/4 inches to the right of

45° mark in 1/16-inch increments.

When making a cross cut or rip cut, align

your line of cut with the left side of the notch

by the 0

0

indicator. Since blade thicknesses

vary, always make a trial cut in scrap

material along a guideline to determine how

much, if any, the guideline must be offset to

produce an accurate cut.

NOTICE: Do not bind the blade in the cut. It

could cause the saw to “kickback” towards

you, which could result in serious injury.

WARNING:

If the blade comes

in contact with the workpiece before it

reaches full speed, it could cause the saw

to “kickback” towards you, which could

result in serious injury.

MAKING RIP CUTS

The combination blade provided with your

saw is for both cross cuts and rip cuts.

Ripping is cutting lengthwise with the grain

of the wood (Fig.12).

When rip cutting large sheet, use a straight

edge (Fig.13).

1. Secure the workpiece.

2. Clamp a straight edge to the workpiece

using C-clamps.

3. Carefully guide the saw along the straight

edge to achieve a straight rip cut.

WARNING:

ALWAYS clamp and

support workpiece securely. ALWAYS

maintain proper control of saw. Failure to

clamp and support workpiece and loss of

control of saw could result in serious injury.

BEVEL CUTTING

The angle of cut can be adjusted to any

desired setting between 0°and 50°.

NOTICE: When making 50° bevel cuts, the

blade should be set at full depth of cut.

Since blade thicknesses vary and different

angles require different settings, always

make a trial cut in scrap material along

a guideline to determine how much you

should offset the guideline on the workpiece

to be cut.

OPERATION

FIG. 12

Desired width

of cut

FIG. 13

Desired line

of cut

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare