Master-force 15A Betreibershandbuch PDF herunterladen (Seite 12)

Page 11

ASSEMBLY

MOUNTING THE WHEEL (FIG. 4)

Only use grinding

wheels with maximum safe operating

speed rated at or above 80m/s. Never use

damaged or imbalance grinding wheels.

Grinding wheel type 27 is recommended

to use on this grinder.

1. Unplug the angle grinder.

2. Make sure that the guard is securely

in place.

3.

Place the inner ange on the spindle;

make sure that the ange is positioned

so that the shape of the opening in the

ange corresponds with the shape at

the base of the spindle.

4. Place the grinding wheel on the spindle.

Check the rated speed on the grinding

wheel. DO NOT use a wheel with a

rated speed lower than the speed

shown on the grinder nameplate.

NOTICE: The maximum wheel thickness is

1/4”, and the center hole dimension

must be 7/8”.

5. Thread the outer ange on the spindle

with the at side of the ange facing up,

making sure that the opening in the wheel

is positioned around the raised portion of

the outer ange.

6. Press the spindle lock button to prevent

movement of the spindle.

7. Keep the spindle lock button pressed

in; tighten the threaded outer ange by

turning it clockwise with the wrench.

8. Remove the wrench and loosen the

spindle lock button.

FIG. 4

WARNING:

OPERATION

SWITCH ON AND OFF

FIG. 5

WARNING:

Make sure you can

operate the switch easily and turn it off

before plugging grinder into a power

source.

1. To turn the tool “ON,” slide the ON/OFF

switch forward, and then apply pressure

to the trigger switch.

2.

To turn the tool “OFF,” release the trigger

switch; it will return to the “OFF”

position automatically.

FIG. 5

Trigger switch

Lock off switch

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare