Master-force 15A Bedienungsanleitung PDF herunterladen (Seite 68)

9-13

IM 34M06H33-01E 2nd Edition : Oct. 2011-00

9.3.2 Setup Function (of Firmware REV03 or Later)

Slave address setup and configuration registration can be performed via the monitor

port. Connect the monitor port of the module to the serial port of a PC using an RS-232C

cross cable.

 Slave Address Setup

You can perform slave address setup without using an addressing device, but you can

only proceed with one slave at a time in Configuration mode by connecting one blank

slave (slave with address 0), and changing its address from 0 to the required address.

TIP

To change the address of a slave other than a blank slave, set the address to 0 temporarily before

setting it to the new address.

CAUTION

- You cannot connect two or more blank slaves concurrently.

- Always perform slave address modification in Configuration mode. When the module is

in Protected mode with automatic address assignment enabled, setting to address 0 is

not allowed.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 86 87

Keine Kommentare

Master-force 15A Bedienungsanleitung Seite 68