Master-force 241-0303 Betreibershandbuch PDF herunterladen (Seite 16)

LED WORKLIGHT (Fig. 6)

The LED worklight, located on

the front of the Impact Driver, will

illuminate when the trigger switch is

depressed. This provides additional

light on the surface of the workpiece

for operation in lower-light areas. The

LED worklight will turn off when the

trigger switch is released.

INSTALLING BITS (Fig.7)

1. Lock the trigger switch by placing

the direction-of-rotation selector in

the OFF (center) position.

2. With one hand, pull the sleeve

toward the front of the tool, and

hold it in place.

3. With the other hand, insert the

1/4-in. bit into the hexagonal hole

in the bit retainer.

4. Release the sleeve and check that

it returns to its original position.

WARNING! If the sleeve does not return to its original position, the bit is not

correctly installed. Retry until the bit is properly installed.

NOTE: When the bit diameter is larger than 1/4 in., use a suitable adapter

(available separately) to install the bit.

REMOVING BITS (Fig.7)

WARNING! Use protective gloves when removing the bit from the tool, or

ﬁrst allow the bit to cool down. The bit may be hot after prolonged use.

1. Lock the trigger switch by placing the direction-of rotation selector in the

OFF (center) position.

2. Pull the sleeve towards the front of the tool, and hold it in place.

3. Remove the bit from the hexagonal hole in the bit retainer.

4. Release the sleeve.

TIGHTENING AND LOOSENING SCREWS AND NUTS

1. Install the correct bit.

2. Apply just enough pressure to keep the bit engaged on the screw or nut.

3. Apply minimal pressure to the trigger switch initially. Increase the speed

only when full control can be maintained.

Fig. 7

Fig. 6

LED worklight

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Master-force 241-0303 Betreibershandbuch Seite 16